GT6 disk brake parts NEEDED for update

Post Reply
User avatar
Victoracing
Posts: 270
Joined: Mon Feb 27, 2017 4:34 pm
Location: South Jersey

GT6 disk brake parts NEEDED for update

Post by Victoracing » Wed Aug 07, 2019 12:04 pm

. . . . . :?

I am ready to convert 100/66/L to front disk brakes. It now has stock 1959 drum brakes.

I need the hard parts, or at least the part numbers, size, make and year of bits that will work together.

ie: uprights (vertical link)
stub axle
upper ball joint
lower trunnion
hub for 4" bc, stock Courier 14" rim
caliper
caliper bracket … custom?
rotor
pads
master cylinder … 0.70 or 0.75 or ?

I would certainly consider good used parts.
Please chime in if I am leaving a critical piece off the list.

Thanks for your help.
Gary C
the Registry guy,
Gary Cossaboon

Jay Laifman
Posts: 4
Joined: Fri Aug 17, 2018 4:21 pm

Re: GT6 disk brake parts NEEDED for update

Post by Jay Laifman » Sat Dec 14, 2019 10:20 pm

We have Spitfire discs on our Mk6. I am happy to help identify anything you need. We have two different types of uprights. We've also learned the hard way that there are different lower trunions. And they put the suspension in different locations! I'll provide more, including pictures, later.

Jay Laifman
Posts: 4
Joined: Fri Aug 17, 2018 4:21 pm

Re: GT6 disk brake parts NEEDED for update

Post by Jay Laifman » Sat Dec 14, 2019 10:24 pm

Best I can tell, we have all that parts from this Moss Motors diagram:

https://mossmotors.com/triumph-spitfire ... spension-7

That is, 11 through 20.

Jay Laifman
Posts: 4
Joined: Fri Aug 17, 2018 4:21 pm

Re: GT6 disk brake parts NEEDED for update

Post by Jay Laifman » Sun Dec 15, 2019 12:11 am

Here are pictures. Note that this picture shows the older style upright that was on the Elva from the factory. As far as I know, that's also what the Spitfires later had. But there is also another, newer Spitfire upright that doesn't have that thin rib down the length of it - instead it is a larger round arm. I don't know which is stronger. The later one has the caliper mounts built into it. The one in the picture has a bolted on mount. We have both.
Attachments
Brakes 2.jpg
Brakes 1.jpg

Jay Laifman
Posts: 4
Joined: Fri Aug 17, 2018 4:21 pm

Re: GT6 disk brake parts NEEDED for update

Post by Jay Laifman » Sun Dec 15, 2019 12:13 am

I have seen comments online about different uprights that have a zirc fitting at the bottom that feeds the brass trunion. It sounds like some people way those don't work and putting the wrong grease in there can cause problems. I haven't focused on that issue, but plan on when we get closer to reassembling the car.

Post Reply

Who is online

Users browsing this forum: No registered users and 3 guests